Protocol analysis
R&S
®
RTO6
660User Manual 1801.6687.02 ─ 05
Table 13-15: Content of the decode result table
Column Description
State Overall state of the frame
Frame start Time of frame start in relation to the trigger point
Type Frame type
Status [bin] Status value
ID Value [hex] Identifier value
Symbolic Data Symbolic data value
Translation Symbolic label name defined in the label list
CRC [hex] CRC sequence value
Bit rate Value of the bit rate
Tools
Press "Display settings" in the "Decode Results"
table to access the "Display" tab.
Remote commands
Remote commands to retrieve decode results are described in Chapter 24.17.1
1.3,
"Decode results",
on page 1909.
13.10.6 Search on decoded SENT data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search
"Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 419.
13.10.6.1 SENT search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
SENT (option R&S RT
O6-K520)
To Next Page
Loading...
