R&S RTO6 - 13.25.5 Search on decoded 8 b;10 b data; 13.25.5.1 8 b;10 b search setup

To Next Page

To Previous Page

Protocol analysis

R&S

RTO6

931User Manual 1801.6687.02 ─ 05

Table 13-48: Content of the decode result table

Column Description

Symbol Shows the index number of the symbol

State Overall state of the symbol

Start Time of the symbol start in relation to the trigger point

K/D Code The K/D code

8-bit The 8-bit value

10-bit 10-bit output value

Tools

Press "Display settings" in the "Decode Results" table to access the "Display" tab.

Remote commands

Remote commands are described in Chapter 24.17.26.3, "Decode results",

on page 2339.

13.25.5

Search on decoded 8b/10b data

Using the search functionality, you can find various events in the decoded data, the

same events which you also can trigger on. Before you can start the search, you have

to configure the bus correctly and acquire decoded data.

To search on decoded data, set the search "Source" to the serial bus that is configured

for the protocol to be analyzed.

See also Chapter 11, "Search functions", on page 419.

13.25.5.1 8b/10b search setup

Access: [Bus] > "Shortcuts" tab > "Setup search"

8b/10b (option R&S R

O6-K590)

Other manuals for R&S RTO6