R&S RTO6 - 24.10.2.3 Waveform data export

Remote control commands
R&S
®
RTO6
1453User Manual 1801.6687.02 ─ 05
REFCurve<m>:RESCale:HORizontal:POSition <Of
fset>
Moves the waveform horizontally
. Enter a value with a time unit suitable for the time
scale of the diagram. Positive values shift the waveform to the right, negative values
shift it to the left.
Suffix:
<m>
.
1..4
Parameters:
<Offset> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Default unit: s
Usage: Asynchronous command
24.10.2.3 Waveform data export
Commands for saving waveform data to file are described in Chapter 24.16.4, "W
ave-
form data export to file", on page 1649.
Commands for reference waveforms are listed below.
REFCurve<m>:DATA:STYPe?.......................................................................................1453
REFCurve<m>:DATA:HEADer?.....................................................................................1453
REFCurve<m>:DATA[:VALues]?....................................................................................1454
REFCurve<m>:DATA:STYPe?
Returns the signal type of the source of the reference waveform.
Suffix:
<m>
.
1..4
Reference waveform
Return values:
<SignalType> SOUR | SPEC | CORR | NONE
SOURce = normal signal
SPECtrum = FFT spectrum, specific math signal
CORRelation = correlated signal, specific math signal
NONE = undefined
Usage: Query only
REFCurve<m>:DATA:HEADer?
Returns information on the reference waveform.
Waveform analysis