Instrument setup
R&S
®
RTO6
99User Manual 1801.6687.02 ─ 05
Enable user defined preset
If enabled, the settings from the selected preset file are restored when the
[Preset]
key
is pressed.
If disabled, [Preset] sets the instrument to the factory defaults.
Remote command:
USRDefined:RST[:ENABle] on page 1322
4.6.2 Factory preset
Access: "Menu" > "Settings" > "Preset" > "Factory"
Restore factory defaults
Resets the instrument to the factory default settings, to the initial state. Factory settings
comprise all instrument settings, including display, intensity and transparency settings.
After loading factory defaults, perform a self-alignment to synchronize the signal data.
Remote command:
Chapter 24.7.1, "System"
, on page 1296
4.6.3 Restoring settings
When you have changed many different settings on the instrument and are no longer
sure which settings are causing which ef
fect in the measurement, you may want to
restore the default settings and start anew
. The following methods are available:
●
Saving instrument settings to a user-defined preset and restoring the instrument
settings to user-defined default values
●
Restoring all settings on the R&S RTO6 to the factory-defined values
●
Restoring settings from a file (see "To load settings from a saveset file"
on page 451)
For details on save/recall instrument settings and associated remote commands, see
Chapter 12.1.1, "Savesets", on page 445.
To save a user-defined preset
1. Open the "Menu" > "Settings" > "Preset" tab.
2. Enter a name for the preset file. Select the file format.
3. Tap Save.
Preset setup
To Next Page
Loading...
