Remote control commands
R&S
®
RTO6
1664User Manual 1801.6687.02 ─ 05
HCOPy:IMMediate<m>[:DUM]
Starts the immediate output of the display image, depending on the HCOPy:
DESTination<1..2>
destination setting.
By default, screenshots are inverted when saving them with remote commands. If you
want the screen display in the screenshot, turn inversion of
f (HCOPy:DEVice<m>:
INVerse).
To get a correct screenshot of the diagrams, results, and dialog boxes, turn on the dis-
play using SYST:DISP:UPD ON.
Suffix:
<m>
.
1..2
Selects the output configuration.
Example:
SYST:DISP:UPD ON
HCOP:DEST 'MMEM'
MMEM:NAME 'C:\Temp\Print.bmp'
HCOP:IMMediate; *OPC?
Example: See Chapter 24.3.5.1, "Saving a screenshot to file",
on page 1266
Usage: Event
Asynchronous command
HCOPy:IMMediate<m>:NEXT
Starts the output of the next display image, depending on the HCOPy:
DESTination<1..2> destination setting.
If the screenshot is saved to a file, the file name used in the last saving process is
automatically counted up to the next unused name.
Suffix:
<m>
.
1..2
Selects the output configuration.
Example: See
Chapter 24.3.5.1, "Saving a screenshot to file",
on page 1266
Usage: Event
Asynchronous command
24.16.9 Reports
The following commands configure and save report files. T
o configure the screenshot
that is included in the report, use the commands explained in Chapter 24.16.8,
"Screenshots"
, on page 1660.
REPort:LANGuage.......................................................................................................1665
REPort:PAPersize........................................................................................................ 1665
REPort:LOGType.........................................................................................................1665
Data management
To Next Page
Loading...
