Protocol analysis
R&S
®
RTO6
608User Manual 1801.6687.02 ─ 05
Show thresholds
If enabled, the threshold levels are displayed in the diagram.
Remote command:
BUS<m>:
THReshold on page
1671
13.8.2.2 LIN display
Access: [Bus] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 487.
LIN Specific Label Settings
Label lists are protocol-specific. Label lists for LIN are available in CSV and PTT for-
mat.
You can also apply an existing LIN description file.
A LIN label file contains two values for each identifier:
●
Identifier value
●
Symbolic name for the identifier
Example of a LIN PTT file
# ----------------------------------------------------------------------------
@FILE_VERSION = 1.0
@PROTOCOL_NAME = lin
# ----------------------------------------------------------------------------
# Labels for LIN protocol
# Column order: Identifier, Label
# ----------------------------------------------------------------------------
# Labels for standard addresses
0x3F,Temperature
1Ch,Left brake
20h,Right brake
# Following ID is provided as integer
33,Mirror
0x37,Indoor lights
# Labels for reserved addresses
0x3C,Master_Request_Frame
0x3D,Slave_Response_Frame
# ----------------------------------------------------------------------------
The LIN description file (ldf) contains information about the assignment of the LIN
frames to the nodes. The format and syntax are defined in the LIN specification.
A LIN ldf file contains the following sections:
●
Header
●
Node section
●
Signal section
●
Frame section
LIN (option R&S R
T
O6-K520)
To Next Page
Loading...
