Remote control commands
R&S
®
RTO6
1556User Manual 1801.6687.02 ─ 05
This function is only available in automatic reference level mode (see REFLevel<m>:
LDETection on page 1552
).
Suffix:
<m>
.
Valid suffix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Value> ON | OFF
Usage: Asynchronous command
REFLevel<m>:AUTO:COUNt <V
alue>
Defines the number of histograms from which the average is calculated.
Prerequisites:
●
REFLevel<m>:
AUTO[:STATe] is set to ON
●
REFLevel<m>:LDETection on page 1552 is set to AUTO
Suffix:
<m>
.
V
alid suf
fix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Value>
Usage: Asynchronous command
24.12.15.3 Manual configuration
REFLevel<m>:ABSolute:HIGH
...................................................................................... 1556
REFLevel<m>:ABSolute:LOW.......................................................................................1557
REFLevel<m>:ABSolute:TDIStance...............................................................................1557
REFLevel<m>:ABSolute:BDIStance...............................................................................1558
REFLevel<m>:ABSolute:MLEVel................................................................................... 1558
REFLevel<m>:ABSolute:ULEVel................................................................................... 1558
REFLevel<m>:ABSolute:LLEVel....................................................................................1559
REFLevel<m>:RELative:UPPer..................................................................................... 1559
REFLevel<m>:RELative:MIDDle....................................................................................1560
REFLevel<m>:RELative:LOWer.................................................................................... 1560
REFLevel<m>:ABSolute:HIGH <Value>
The signal value that represents a high level.
Automatic measurements
To Next Page
Loading...
