R&S RTO6 - Page 1557

Remote control commands
R&S
®
RTO6
1557User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
V
alid suf
fix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Value>
Example:
REFLevel2:ABSolute:HIGH 0.015
Sets the high signal level for C1W1 to 15 mV
. C1W1 corre-
sponds to suf
fix number 2.
Usage: Asynchronous command
REFLevel<m>:ABSolute:LOW <Value>
The signal value that represents a low level.
Suffix:
<m>
.
Valid suf
fix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Value>
Example:
REFLevel2:ABSolute:Low 0.0015
Sets the low signal level forC1W1 to 1.5 mV
. C1W1 corresponds
to suffix number 2.
Usage: Asynchronous command
REFLevel<m>:ABSolute:TDIStance <V
alue>
The distance between the high signal level and the upper reference level.
Suffix:
<m>
.
Valid suf
fix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Value>
Example:
REFLevel2:ABSolute:TDIStance 0.0002
Sets the top distance for C1W1 to 0.2 mV
. C1W1 corresponds to
suf
fix number 2.
Example: See: "Manual reference level definition using absolute values"
on page 1262
Usage: Asynchronous command
Automatic measurements