R&S RTO6 - 8.1.2.3 Configuring the cursor display; 8.1.2.4 Saving measurement results to file; 8.1.3 Settings for cursor measurements; 8.1.3.1 Setup tab

Measurements
R&S
®
RTO6
288User Manual 1801.6687.02 ─ 05
8.1.2.3 Configuring the cursor display
By default, the cursors are displayed as lines in the diagrams and labeled according to
the syntax: Cu<cursor set number>.<1|2>
For example, the cursors for the cursor set 2 are labeled 2.1 and 2.2. The horizontal
and the vertical cursors lines have the same labels.
Y
ou can change the default cursor display and labels.
T
o set the cursor style
1. Open the "Menu" and select "Settings".
2. Select "Appearance".
3. Select the "Cursor" tab.
4. Select the cursor style. See also: "Cursor style" on page 85.
To add labels to cursor lines
1. Open the "Cursors" dialog box, for example, with "Menu" > "Cursor".
2. Select the subtab for the cursor set you want to configure.
3. Select the "Advanced" tab.
4. For each vertical and horizontal cursor, enter a label.
5. Select "Show labels".
8.1.2.4 Saving measurement results to file
1. Open the "Menu" and select "Save/Recall".
2. Select the "Save" tab.
3. Select "Results".
4. Select the results that you want to export.
5. Save the file.
8.1.3 Settings for cursor measurements
Cursor measurements are configured in the "Cursors" dialog box.
8.1.3.1 Setup tab
The "Setup" tab contains the settings for cursor measurements.
The cursor style and position of the measurement results is defined in the
"Settings"
>
"Appeareance" > "Cursor" dialog box.
Cursor measurements