R&S RTO6 - 13.7.6.4 Symbolic search results

Protocol analysis
R&S
®
RTO6
603User Manual 1801.6687.02 ─ 05
Message
Sets the message to be triggered or searched for
.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same message if symbolic trigger and symbolic search is used at
the same time.
Remote command:
SEARch:
TRIGger:CAN:SYMBolic:MSGValue on page 1835
Search signals
Enables the search for a specific signal value that is part of the selected message.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:SSIGnals on page 1835
Signal
Sets the signal name to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same signal if symbolic trigger and symbolic search is used at
the same time.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:SIGValue on page 1835
Condition
Sets the operator to set a specific data pattern or symbolic value ("Equal" or "Not
equal") or a data range.
This condition is also used to search for data, see "Data setup: DLC, NDB, Condition,
Data min, Data max" on page 598.
Remote command:
SEARch:TRIGger:CAN:DCONdition on page 1820
Value, Value (min)
Defines the data pattern or selects a symbolic data value.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:DMIN on page 1836
SEARch:TRIGger:CAN:SYMBolic:SGEValue on page 1836
Value (max)
The second data pattern is required to specify a range with conditions "In range" and
"Out of range".
Remote command:
SEARch:TRIGger:CAN:SYMBolic:DMAX on page 1836
13.7.6.4 Symbolic search results
If a DBC file is applied, you can search for symbolic messages and signals as descri-
bed in Chapter 13.7.6.3, "Symbolic search", on page 602. As ususal, the search results
CAN and CAN FD (option R&S R
T
O6-K520)