R&S RTO6 - Page 598

Protocol analysis
R&S
®
RTO6
598User Manual 1801.6687.02 ─ 05
FD bits
For standard settings " CAN FD" and "Any"
, you can search for CAN FD-specific bits.
For details, see
"FD bits" on page 590.
The setting is available in CAN FD option.
Remote command:
SEARch:TRIGger:CAN:FDATa[:FDF] on page 1825
SEARch:TRIGger:CAN:FDATa:BRS on page 1825
SEARch:TRIGger:CAN:FDATa:ESI on page 1825
Data setup: DLC, NDB, Condition, Data min, Data max
The data setup consists of the number of bytes, the condition, and one or two data pat-
terns.
The data setup settings are the same as in the CAN trigger setup, see "Data setup:
DLC, NDB, Transfer, Condition, Data min, Data max" on page 591.
The data condition setting is also used for symbolic signal search, see Chap-
ter 13.7.6.3, "Symbolic search", on page 602.
Remote command:
SEARch:TRIGger:CAN:DCONdition on page 1820
SEARch:TRIGger:CAN:DMIN on page 1821
SEARch:TRIGger:CAN:DMAX on page 1821
SEARch:TRIGger:CAN:DLCCondition on page 1821
SEARch:TRIGger:CAN:DLC on page 1822
SEARch:RESult:CAN:FRAMe<m>:NDBYtes? on page 1822
Data position
The data position sets the location in the data field where the instrument looks for the
specified data pattern.
The setting is available in CAN FD option.
The position can be defined if the data field of the frame is longer than 8 bytes - if DLC
≥9.
For details, see "Data position" on page 592.
Remote command:
SEARch:TRIGger:CAN:FDATa:DPOPerator on page 1822
SEARch:TRIGger:CAN:FDATa:DPOSition on page 1823
SEARch:TRIGger:CAN:FDATa:DPTO on page 1823
Error Condition
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the CAN trigger setup, see "Error conditions"
on page 592.
Remote command:
SEARch:TRIGger:CAN:CRCerror on page 1824
SEARch:TRIGger:CAN:BITSterror on page 1824
SEARch:TRIGger:CAN:FORMerror on page 1824
CAN and CAN FD (option R&S RT
O6-K520)