R&S RTO6 - 24.8.12 AUX OUT

Remote control commands
R&S
®
RTO6
1385User Manual 1801.6687.02 ─ 05
Parameters:
<Offset> Range: -100E-9 to 100E-9
Increment: 10E-15
*RST: 0
Default unit: s
Usage: Asynchronous command
PROBe<m>:SKEState <ProbeSkew>
If enabled, the skew of all connected active probes is measured, displayed, and used
for deskewing.
Suffix:
<m>
.
1..4
The suffix is irrelevant. The setting af
fects all active channels.
Parameters:
<ProbeSkew> ON | OFF
*RST: OFF
Usage: Asynchronous command
CHANnel<m>:SKEW:EXTended <ExtendSkew>
Enables a higher skew value range that can be set with CHANnel<m>:SKEW:
TIME
on page 1384. The skew extension reduces the maximum number of acquisitions in
the memory.
Suffix:
<m>
.
1..4
The suffix is irrelevant. The setting af
fects all active channels.
Parameters:
<ExtendSkew> ON | OFF
*RST: OFF
Usage: Asynchronous command
24.8.12 AUX OUT
CALibration:SOURce:FREQuency
................................................................................. 1386
CALibration:SOURce:STATe..........................................................................................1386
Acquisition and setup