Remote control commands
R&S
®
RTO6
2440User Manual 1801.6687.02 ─ 05
TRIGger<m>:PARallel:PATTern:WIDTh:DELTa <WidthDelta>
Defines a range around the width value set with TRIGger<m>:
PARallel:
PATTern:
WIDTh[:WIDTh].
Parameters:
<WidthDelta> Range: 0 to 432
Increment: 500E-12
*RST: 0
Default unit: s
Usage: Asynchronous command
24.18.4.8 Serial pattern trigger
See also:
●
TRIGger<m>:
PARallel:
SPATtern:CSOurce[:VALue] on page 2433
●
TRIGger<m>:PARallel:SPATtern:EXPRession[:DEFine] on page 2433
TRIGger<m>:PARallel:SPATtern:CSOurce:EDGE <ClockEdge>
Sets the edge of the clock signal. The bit value is determined at the crossing of the
clock edge and the logical threshold.
Parameters:
<ClockEdge> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
TRIGger<m>:PARallel:SPATtern:PATTern <Pattern>
Defines the serial bit string on which to trigger.
Parameters:
<Pattern> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The bit value X (don't care) is not
allowed.
Usage: Asynchronous command
24.18.5 MSO data
To export data of digital channels and parallel buses to file, use the following com-
mands:
●
EXPort:WAVeform:
SOURce on page 1649
●
EXPort:WAVeform:NAME on page 1651
●
EXPort:WAVeform:SAVE on page 1651
Mixed signal option (MSO, R&S R
T
O6-B1)
To Next Page
Loading...
