R&S RTO6 - Page 1651

Remote control commands
R&S
®
RTO6
1651User Manual 1801.6687.02 ─ 05
Parameters:
<MltChXpt> ON | OFF
*RST: OFF
Usage: Asynchronous command
CHANnel<m>:EXPortstate <ExportState>
Includes or excludes the indicated channel in waveform export. The data of channel
waveform 1 is exported.
The commands takes effect if
EXPort:WAVeform:MULTichannel is ON.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<ExportState> ON | OFF
If you enable the multichannel export, the export state of all
active channels is automatically set ON.
*RST: OFF
Usage: Asynchronous command
EXPort:WAVeform:NAME <FileName>
Sets the file name, file format and path to save the waveform to.
See also: Chapter 12.2.1, "W
aveform export files",
on page 453
Parameters:
<FileName> String with path and file name with extension .xml, .bin, or .csv
Example:
EXPort:WAVeform:NAME 'C:\temp\Export_Chl1.xml'
EXPort:
WAVeform:
SAVE
Saves the waveform data in XML format to
C:\temp\Export_Ch1.xml.
Example:
EXPort:WAVeform:NAME 'C:\temp\Export_Ch2.bin'
EXPort:WAVeform:
SAVE
Saves the waveform data in binary format to
C:\temp\Export_Ch2.bin.
Usage: Asynchronous command
EXPort:WAVeform:SAVE
Saves the waveform(s) to the file specified with EXPort:WAVeform:
NAME. The file
format is also set using the ...NAME command.
Example: See Chapter 24.3.5.2, "Exporting waveform data to file",
on page 1267
Data management