Protocol analysis
R&S
®
RTO6
908User Manual 1801.6687.02 ─ 05
4. Tap "Serial bus" and select the serial bus that is set to M-PHY, e.g.:
The "Protocol" selection is then automatically set to "M-PHY".
5. Select the "T
ype" to use in the M-PHY protocol analysis.
6. To refine the trigger settings, configure additional settings, which are available for
some trigger types.
For details, see Chapter 13.24.3.1, "M-PHY trigger settings", on page 896.
13.24.3.3 SSIC trigger settings
The setting is available for SSIC option R&S RTO6-K570.
Frame type
Selects the frame type for the M-PHY SSIC.
The SSIC trigger frames and fields are the same as for USB3.1, see "Frame types"
on page 842.
Error types, Enable
The table lists the error types you can trigger on. Select the required errors in the
"OR"
column.
M-PHY and USB SSIC (option R&S R
T
O6-K580 and K570)
To Next Page
Loading...
