Protocol analysis
R&S
®
RTO6
602User Manual 1801.6687.02 ─ 05
Remote command:
●
BUS<m>:CAN:
FRAMe<n>:
SDATa? on page 1833
●
BUS<m>:CAN:FRAMe<n>:SDEXport? on page 1815
13.7.6.3 Symbolic search
Access:
1. Press [Bus].
2. In the "Setup" tab, set "Protocol = CAN/ CAN-FD".
3. In the "Shortcuts" tab, select "Setup search".
4. In the search dialog, set the "Type" = "Symbolic".
If a DBC file is applied, the symbolic search for messages and signal, which are
defined in the DBC file, is available. Symbolic search is an alternative to the other
search criteria, you can either search for symbolic values or for an AND-combination of
the other 5 criteria.
If symbolic search is active, the "Frame type" is automatically set to "Data", and the
"Identifier" is shown for information.
Symbolic
Enables the symbolic search and disables all other search criteria.
Remote command:
SEARch:
TRIGger:CAN:
SSYMbolic on page 1834
CAN and CAN FD (option R&S RT
O6-K520)
To Next Page
Loading...
