R&S RTO6 - 5.6.10 Calibration results; 5.6.11 Probe adapter R&S RT-Z2 T

Acquisition and waveform setup
R&S
®
RTO6
169User Manual 1801.6687.02 ─ 05
Remote commands:
●
PROBe<m>:ID:SWVersion?
on page 1363
●
PROBe<m>:ID:PRDate? on page 1363
●
PROBe<m>:ID:PARTnumber? on page 1364
●
PROBe<m>:ID:SRNumber? on page 1364
●
PROBe<m>:SETup:CAPacitance? on page 1364
●
PROBe<m>:SETup:IMPedance? on page 1364
5.6.10 Calibration results
To check the attributes of the connected probes, select "Info" > "Cal Results" in the
"Probes" tab.
5.6.11 Probe adapter R&S RT‑Z2T
Using the R&S RT
‑Z2T probe interface adapter, you can connect selected Tektronix
active probes with TekProbe BNC
TM
level II interface.
1. Connect the R&S RT‑Z2T adapter to the channel input.
2. Connect the probe to the adapter.
The instrument identifies the adapter. The R&S RTO6 lists the supported Tektronix
probes as "Predefined probe".
Probes