R&S RTO6 - 24.17.25.7 Search settings USB SSIC (Option R&S RTO6-K570)

Remote control commands
R&S
®
RTO6
2325User Manual 1801.6687.02 ─ 05
TRIGger<m>:MPHY:SSIC:IOPerator <Frame>, <Field>, <Operator>
TRIGger<m>:MPHY
:SSIC:FRAMe<n>:FLD<o>:IOPerator
<IndexOperator>
Sets the operator for the index in the selected field of the selected frame.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
<n> *
Specifies the field number within the frame.
<o> *
Parameters:
<IndexOperator>
EQUal | INRange | RANGe
EQUal
This condition requires one endpoint value to be set using
TRIGger<m>:
MPHY:
SSIC:FRAMe<n>:FLD<o>:IMIN.
INRange | RANGe
This condition requires a range of endpoint values to be set
using TRIGger<m>:MPHY:SSIC:FRAMe<n>:FLD<o>:IMIN
and TRIGger<m>:MPHY:SSIC:FRAMe<n>:FLD<o>:IMAX.
*RST: INRange
24.17.25.7 Search settings USB SSIC (Option R&S RTO6-K570)
There are two commands for each parameter
, that you can use for defining the SSIC
search settings.
For example, to set the Frame type =ACK > Field =Route String >Data value you can
use one of the following commands:
●
SEARch:TRIGger:MPHY:SSIC:FRAMe13:FLD1:DMIN 01100
Defines the parameter by using the index <m> for the frame number and <n> for
the field number.
●
SEARch:TRIGger:MPHY:SSIC:DMIN "ACK", "Route String", 01100
Defines the parameter by using the frame and field name.
SEARch:TRIGger:MPHY:SSIC:ERENable <SearchName>,<ErrorName>, <Enabler>
SEARch:TRIGger:MPHY:SSIC:ERRor<m>:ENABle <SearchName>,<Enable>
SEARch:TRIGger:MPHY:SSIC:ERRor<m>:ENABle? <SearchName>
Enables or disables the searching for an error condition.
Suffix:
<m>
.
*
Parameters:
<Enable> ON | OFF
*RST: ON
Protocols