R&S RTO6 - 24.16.2 Savesets and one file

Remote control commands
R&S
®
RTO6
1648User Manual 1801.6687.02 ─ 05
Usage: Setting only
24.16.2 Savesets and one file
SA
V
eset:CONFig:PREView...........................................................................................1648
SAVeset:ONEFile:NAME...............................................................................................1648
SAVeset:ONEFile:SAVE................................................................................................1648
SAVeset:ONEFile:OPEN...............................................................................................1648
SAVeset:ONEFile:USERpref......................................................................................... 1648
SAVeset:CONFig:PREView <Include>
If set to OFF, the saveset is stored without the preview image to reduce the file size.
Use the command each time before you save a saveset.
Parameters:
<Include> ON | OFF
*RST: ON
Usage: Asynchronous command
SAVeset:ONEFile:NAME <Name>
Sets the path and the file name of the One File. The file format is ZIP.
Parameters:
<Name> String parameter
Usage: Asynchronous command
SAVeset:ONEFile:SAVE
Usage: Event
Saves the One File data to the file that is specified with SAVeset:ONEFile:NAME.
SAVeset:ONEFile:OPEN
Loads the One File that is specified with SAVeset:ONEFile:
NAME.
Usage: Event
SAVeset:ONEFile:USERpref <Include>
If ON, the user preferences settings are also restored together with the saveset and
reference waveform. User preferences settings include the user-specific display set-
tings like diagram layout, toolbar, intensity and transparency settings.
Data management