R&S RTO6 - Page 1647

Remote control commands
R&S
®
RTO6
1647User Manual 1801.6687.02 ─ 05
This command has the same effect as the combination of MMEMory:
LOAD:STATe and
*RCL
.
Parameters:
'<FileSource>' String parameter specifying the path and filename of the source
file. Wildcards are not allowed.
Example:
MMEM:RCL 'C:\mysavefile.dfl'
Loads and activates the instrument settings from the file
mysavefile.dfl located in the directory C:\.
Usage: Event
MMEMory:STORe:STATe <MemoryNumber>, <FileName>
Stores the instrument settings from the specified internal memory to the specified file.
To store the current instrument settings to the internal memory
, use *SAV first.
Setting parameters:
<MemoryNumber> Number of the internal memory
Range: 1 to 99
<FileName> String parameter specifying the complete path and filename of
the source file.
Example:
*SAV 4
MMEM:STORe:
STATe 4,'C:
\Settings\Settings_1051.dfl'
Saves current instrument settings to the internal memory num-
ber 4. Then stores the settings from the internal memory number
4 to the file
C:\Settings\Settings_1051.dfl.
Usage: Setting only
MMEMory:LOAD:STATe <MemoryNumber>, <FileName>
Loads the instrument settings from the specified file to the specified internal memory.
After the file has been loaded, the settings must be activated using a *RCL
command.
Setting parameters:
<MemoryNumber> Number of the internal memory
Range: 1 to 99
<FileName> String parameter specifying the complete path and filename of
the source file.
Example:
MMEM:LOAD:STATe 4,'C:
\Settings\Settings_1051.dfl'
*RCL 4
Loads instrument settings from the file
C:\Settings\
Settings_1051.dfl to the internal memory
number 4, and then activates the settings in internal memory
number 4.
Data management