R&S RTO6 - 24.17.26.5 Search results

Remote control commands
R&S
®
RTO6
2344User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:EBTB:TBPA <SearchName>,<TBPattern>
SEARch:TRIGger:EBTB:TBP
A?
<SearchName>
Sets the 10-bit pattern to be searched for, if SEARch:TRIGger:EBTB:STYPe is set to
TB.
Parameters:
<TBPattern>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:EBTB:TYPE <SearchName>,<Type>
SEARch:TRIGger:EBTB:TYPE?
<SearchName>
Selects the type of condition to be searched for. You can search for a certain symbol or
enable a specific error condition.
Parameters:
<Type> SYMBol | ERRor
*RST: SYMBol
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:EBTB:UNK <SearchName>,<UnkError>
SEARch:TRIGger:EBTB:UNK? <SearchName>
Defines, if a search for any unknown symbol error is activated or not.
Parameters:
<UnkError> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
24.17.26.5 Search results
In all SEARch:RESult:
EBTB:SYMBol<m> commands, the suffix <m> selects the
frame number in the list of search results.
SEARch:RESult:EBTB:SCOunt?................................................................................... 2345
SEARch:RESult:EBTB:SYMBol<m>:DATA?....................................................................2345
SEARch:RESult:EBTB:SYMBol<m>:STARt?...................................................................2345
SEARch:RESult:EBTB:SYMBol<m>:STATus?.................................................................2345
SEARch:RESult:EBTB:SYMBol<m>:STOP?................................................................... 2346
Protocols