Instrument setup
R&S
®
RTO6
76User Manual 1801.6687.02 ─ 05
●
Serial buses if a protocol option is activated
●
Parallel buses if MSO option is installed
See also: Chapter 4.3.2, "Color tables", on page
76
Remote command:
DISPlay:
COLor:SIGNal<m>:ASSign on page 1297
Set to default color
Resets the color of the selected waveform to the factory default.
4.3.2 Color tables
Access: "Settings" > "Appearance" > "Color" > "Edit Color Table"
Color tables define the color of the waveform pixels depending on the cumulative
occurrence of the associated values. By default, the intensity of the specific waveform
color varies according to the cumulative occurrence of the values. The more often a
value occurs, the darker the color of the data point is displayed.
The following color tables are provided:
●
"False colors": color changes gradually in a wide color spectrum.
●
"M-Hot"
●
"M-Hsv"
●
"M-Jet"
●
"Spectrum": colors display the wave lengths of the light. Low cumulative occur-
rence is displayed blue like high wave length.
●
"Single Event": single events and very seldom events appear yellow
, a higher
cumulative occurrence is shown with blue color
. This view helps to identify specific
events.
●
"Temperature": color changes gradually from blue (low temperature) to red (high
temperature) with increasing cumulative occurrence.
Appearance settings
To Next Page
Loading...
