R&S RTO6 - 13.11.4.2 Search results

Protocol analysis
R&S
®
RTO6
682User Manual 1801.6687.02 ─ 05
Error
Selects the error type to be searched for
. Y
ou can select one or more error types as
search condition.
The error types are the same as in the CXPI trigger setup, see "Error" on page 675.
13.11.4.2 Search results
To get search results, "Enable"
the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
The columns in the search result table are the same as in the decoding table, see
Chapter 13.11.5, "CXPI decode results", on page 683.
Remote commands:
●
SEARch:RESult:CXPI:FCOunt? on page 1954
●
SEARch:RESult:CXPI:FRAMe<m>:STATe? on page 1955
●
SEARch:RESult:CXPI:FRAMe<m>:STARt? on page 1955
●
SEARch:RESult:CXPI:FRAMe<m>:STOP? on page 1955
●
SEARch:RESult:CXPI:FRAMe<m>:TYPE? on page 1955
●
SEARch:RESult:CXPI:FRAMe<m>:DATA? on page 1954
●
SEARch:RESult:CXPI:FRAMe<m>:DLCV? on page 1954
●
SEARch:RESult:CXPI:FRAMe<m>:WORD<n>:TYPE? on page 1956
●
SEARch:RESult:CXPI:FRAMe<m>:WORD<n>:VALue? on page 1956
●
SEARch:RESult:CXPI:FRAMe<m>:WORD<n>:STATus? on page 1956
CXPI (option R&S R
T
O6-K520)