R&S RTO6 - Page 681

Protocol analysis
R&S
®
RTO6
681User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:CXPI:
DLC:CONDition on page 1949
SEARch:TRIGger:CXPI:DLC:MAX on page 1949
SEARch:TRIGger:CXPI:DLC:MIN on page 1949
DLC Extend
Searches for a DLC extend pattern or a DLC extend range. The setup consists of the
condition and one or two DLC extend patterns.
The DLC extend setup settings are the same as in the CXPI trigger setup, see "DLC
Extend" on page 677.
Remote command:
SEARch:TRIGger:CXPI:DEXTension:CONDition on page 1948
SEARch:TRIGger:CXPI:DEXTension:MAX on page 1948
SEARch:TRIGger:CXPI:DEXTension:MIN on page 1948
Data
Searches for a data pattern or a data range. The setup consists of the condition and
one or two data patterns.
The data setup settings are the same as in the CXPI trigger setup, see "Data"
on page 677.
Remote command:
SEARch:TRIGger:CXPI:DATA:DCONdition on page 1946
SEARch:TRIGger:CXPI:DATA:DMAX on page 1946
SEARch:TRIGger:CXPI:DATA:DMIN on page 1946
Index
Searches for a data index pattern or a data index range. The setup consists of the con-
dition and one or two index patterns.
The index setup settings are the same as in the CXPI trigger setup, see "Index"
on page 678.
Remote command:
SEARch:TRIGger:CXPI:DATA:ICONdition on page 1947
SEARch:TRIGger:CXPI:DATA:IMAX on page 1947
SEARch:TRIGger:CXPI:DATA:IMIN on page 1947
NM
Searches for the value of the network management (NM), 2 bits indicating if the frame
is in wakeup or sleep mode.
Remote command:
TRIGger<m>:CXPI:NM on page 1940
CT
Searches for the value of the counter (CT), 2 bits indicating the continuity of the frame.
Remote command:
SEARch:TRIGger:CXPI:CT on page 1945
CXPI (option R&S RT
O6-K520)