R&S RTO6 - Eye

Remote control commands
R&S
®
RTO6
2502User Manual 1801.6687.02 ─ 05
ADVJitter<m>:RESult:NBAThtub <State>
Enables a noise bathtub plot, a graph of BER in a log scale versus data-dependent jit-
ter (DDN).
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:PN <State>
If enabled, the periodic noise components are considered for the noise bathtub.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:RESult:OBUN <State>
If enabled, the other bounded uncorrelated noise components are considered for the
noise bathtub.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
Eye
ADVJitter<m>:RESult:PHORizontal............................................................................... 2502
ADVJitter<m>:RESult:PVERtical
....................................................................................2503
ADVJitter<m>:RESult:SYNTheticeye..............................................................................2503
ADVJitter<m>:RESult:TYPSynteye................................................................................ 2503
ADVJitter<m>:RESult:PHORizontal <State>
If enabled, adds horizontal periodic components to the data-dependent synthetic eye.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
Jitter analysis and clock data recovery