Remote control commands
R&S
®
RTO6
1619User Manual 1801.6687.02 ─ 05
24.15.10 W
indow search conditions
SEARch:TRIGger:WINDow:DEL
Ta.................................................................................1619
SEARch:TRIGger:WINDow:RANGe...............................................................................1619
SEARch:TRIGger:WINDow:TIMerange.......................................................................... 1620
SEARch:TRIGger:WINDow:WIDTh................................................................................1620
SEARch:TRIGger:LEVel:WINDow:LOWer.......................................................................1621
SEARch:TRIGger:LEVel:WINDow:UPPer....................................................................... 1621
SEARch:TRIGger:WINDow:DELTa <SearchName>,<WidthDelta>
SEARch:TRIGger:WINDow:DELTa? <SearchName>
Defines a range around the "Width" value (see SEARch:TRIGger:WINDow:WIDTh
on page 1620).
Parameters:
<WidthDelta> Range: 0 to 432
Increment: 500E-12
*RST: 0
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:TRIGger:WINDow:RANGe <SearchName>,<RangeMode>
SEARch:TRIGger:WINDow:RANGe? <SearchName>
Selects how the signal run is compared with the window.
Parameters:
<RangeMode>
ENTer | EXIT | WITHin | OUTSide
ENTer
T
riggers when the signal crosses the upper or lower level and
thus enters the window made up of these two levels.
EXIT
Triggers when the signal leaves the window.
WITHin
Triggers if the signal stays between the upper and lower level for
a specified time. The time is defined in various ways by the
SEARch:TRIGger:WINDow:TIMerange command.
OUTSide
Triggers if the signal stays above the upper level or below the
lower level for a specified time. The time is also defined by the
SEARch:TRIGger:WINDow:TIMerange command.
*RST: ENTer
Parameters for setting and query:
<SearchName> Search definition
Search
To Next Page
Loading...
