R&S RTO6 - Page 1618

Remote control commands
R&S
®
RTO6
1618User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:WIDTh:RANGe <SearchName>,<RangeMode>
SEARch:TRIGger:WIDTh:RANGe? <SearchName>
Selects how the range of a pulse width is defined in relation to the width and delta (see
SEARch:
TRIGger:WIDTh:
WIDTh on page 1618 and SEARch:TRIGger:WIDTh:
DELTa on page 1617).
Parameters:
<RangeMode> WITHin | OUTSide | SHORter | LONGer
WITHin
Triggers on pulses inside a given range. The range of the pulse
width is defined by
"Width" and "±Delta".
OUTSide
Triggers on pulses outside a given range. The range definition is
the same as for "Within" range.
SHORter
Triggers on pulses shorter than the given "Width".
LONGer
Triggers on pulses longer than the given "Width".
*RST: WITHin
Parameters for setting and query:
<SearchName> Search definition
Example: See Chapter 24.3.4.1, "Searching for a pulse of specified width",
on page
1266
Usage: Asynchronous command
SEARch:TRIGger:WIDTh:WIDTh <SearchName>,<Width>
SEARch:TRIGger:WIDTh:WIDTh?
<SearchName>
For the ranges "Within" and "Outside", the width defines the center of a range which is
defined by the limits "±Delta".
For the ranges "Shorter" and "Longer", the width defines the maximum and minimum
pulse width, respectively.
The range is defined using SEARch:TRIGger:WIDTh:RANGe.
Parameters:
<Width> Range: 100E-12 to 864
Increment: 100E-9
*RST: 5E-9
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Example: See Chapter 24.3.4.1, "Searching for a pulse of specified width",
on page 1266
Usage: Asynchronous command
Search