R&S RTO6 - 13.27.4.1 Basic setup

Protocol analysis
R&S
®
RTO6
973User Manual 1801.6687.02 ─ 05
13.27.4.1 Basic setup
Access: [App Cockpit]> "Analysis"
>
"Eye Analysis" > "Setup" tab
In the "Setup" tab, you configure the source, the timing reference, and horizontal scale
settings of the eye diagram. The vertical scale of the eye diagram is coupled to the ver-
tical scale of the data source.
You can configure and analyze up to four independent eye diagrams in parallel (vertical
subtabs Eye 1 to Eye 4). Make sure to select the correct eye diagram subtab on the
left before you adjust the settings.
State............................................................................................................................974
Source.........................................................................................................................974
Reference signal......................................................................................................... 974
└ Clock / CDR / Protocol..................................................................................974
└ Clock.............................................................................................................974
└ CDR.............................................................................................................. 975
└ Protocol.........................................................................................................975
Horizontal settings.......................................................................................................975
└ Time units......................................................................................................975
└ Range, Position.............................................................................................975
└ Range UI, Position UI................................................................................... 976
Explicit clock................................................................................................................976
└ Vertical reference level..................................................................................976
└ Clock frequency............................................................................................ 977
DDR (option R&S R
T
O6-K91 )