R&S RTO6 - 24.7.2.8 Cursor appearance

Remote control commands
R&S
®
RTO6
1314User Manual 1801.6687.02 ─ 05
24.7.2.8 Cursor appearance
CURSor<m>:
STYLe
<Style>
Defines how the cursor is displayed in the diagram.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<Style> LINes | LRHombus | VLRHombus | RHOMbus
LINes
The cursors are displayed as lines.
LRHombus
The cursors are displayed as lines. The intersections of the cur-
sors with the waveforms are displayed by rhombus-shaped
points.
VLRHombus
The cursors are displayed only as vertical lines. The intersec-
tions of the cursors with the waveforms are displayed by rhom-
bus-shaped points.
RHOMbus
The intersections of the cursors with the waveforms are dis-
played by rhombus-shaped points.
*RST: LINes
Usage: Asynchronous command
DISPlay:RESultboxes:CUPosition <Position>
Defines the position of the cursor measurement results on the screen.
Parameters:
<Position> PREV | FLOA | DOCK
PREV
Preview: result icon on the signal bar
.
FLOA
Floating result box in front of the diagrams.
DOCK
Docked: fixed tab below the diagrams.
*RST
: DOCK
Usage: Asynchronous command
Instrument setup