R&S RTO6 - 15.6 Configuring the waveform generator; 15.6.1 Configuring a function waveform

Waveform generator (Option R&S RTO6-B6)
R&S
®
RT
O6
1040User Manual 1801.6687.02 ─ 05
Sync start
Selects, which signals generated from the waveform generator are synchronized.
Selecting one of the sync options indicates that the first samples of those signals are
generated at the same time, irrespective of if the generators are on or off. Selecting
one of the coupling options automatically syncs the signals generated by the two wave-
form generators.
Remote command:
GENerator:
SYNC[:COMBination] on page 2463
15.6 Configuring the waveform generator
This chapter explains step-by-step how to configure the waveform generator.
● Configuring a function waveform.........................................................................1040
● Configuring a modulation waveform....................................................................1041
● Configuring a sweep waveform...........................................................................1042
● Configuring an arbitrary waveform......................................................................1042
● Configuring a pattern generator waveform..........................................................1043
15.6.1 Configuring a function waveform
1. Press the [Gen] key on the front panel.
2. Select the "Setup" tab.
3. Under "Operation mode", enable the "Function Gen." button.
4. Select the "Function type" that you want to generate, e.g. "Sine".
5. Depending on the selected "Function type", configure the settings of the waveform
like "Frequency" and "Period".
6. If necessary, change the "Output" settings or add "Noise" to the waveform.
Configuring the waveform generator