Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1172User Manual 1801.6687.02 ─ 05
4. Select the correct channels for the "DC output" and the "AC input" or the "DC
input".
5.
Select the "Settings" tab.
6.
Select whether you want to measure "Turn on" or "Turn off".
7. Set the "Steady state level" and the "Trigger level " according to your requirements.
8. Tap "Execute".
9. Turn on/off the DUT.
On the screen, you can see the measurement. Also, the result box displays the
turn on or the turn off time. For details, see Chapter 19.5.2.1, "Turn on/off results",
on page 1169.
19.5.2.3 Turn on/off settings
In the "Channels" tab, you set the current source and the voltage source, see also:
Chapter 19.2.1, "Channels tab", on page 1134.
In the "Settings" tab, you configure the turn on and the turn off parameters.
Figure 19-2: Settings turn on time
Power path
To Next Page
Loading...
