R&S RTO6 - 24.17.3.4 I²C search settings

Remote control commands
R&S
®
RTO6
1693User Manual 1801.6687.02 ─ 05
24.17.3.4 I²C search settings
In search setup commands, you have to specify the <SearchName> parameter
. It is a
string parameter that contains the search definition name. The commands are similar
to I²C trigger commands.
SEARch:TRIGger:I2C:SCONdition
.................................................................................1693
SEARch:TRIGger:I2C:RCONdition.................................................................................1693
SEARch:TRIGger:I2C:STCNdition................................................................................. 1694
SEARch:TRIGger:I2C:NACKnowledge...........................................................................1694
SEARch:TRIGger:I2C:SADDress...................................................................................1694
SEARch:TRIGger:I2C:ADOR........................................................................................ 1695
SEARch:TRIGger:I2C:ADData.......................................................................................1695
SEARch:TRIGger:I2C:ACONdition.................................................................................1695
SEARch:TRIGger:I2C:AMODe...................................................................................... 1696
SEARch:TRIGger:I2C:ADDRess....................................................................................1696
SEARch:TRIGger:I2C:ADDTo........................................................................................1696
SEARch:TRIGger:I2C:ACCess......................................................................................1697
SEARch:TRIGger:I2C:ADDO<m>:ENABle......................................................................1697
SEARch:TRIGger:I2C:ADDO<m>:ADRType................................................................... 1697
SEARch:TRIGger:I2C:ADDO<m>[:VALue]......................................................................1698
SEARch:TRIGger:I2C:ADDO<m>:RWBit........................................................................1698
SEARch:TRIGger:I2C:DPOPerator................................................................................ 1698
SEARch:TRIGger:I2C:DPOSition...................................................................................1699
SEARch:TRIGger:I2C:DPTO.........................................................................................1699
SEARch:TRIGger:I2C:DCONdition.................................................................................1699
SEARch:TRIGger:I2C:DMIN..........................................................................................1700
SEARch:TRIGger:I2C:DMAX........................................................................................ 1700
SEARch:TRIGger:I2C:ADNack......................................................................................1700
SEARch:TRIGger:I2C:DRNack......................................................................................1700
SEARch:TRIGger:I2C:DWNack..................................................................................... 1701
SEARch:TRIGger:I2C:SCONdition <SearchName>,<Start>
SEARch:TRIGger:I2C:SCONdition? <SearchName>
Enables the search for the start of the message.
Parameters:
<Start> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:RCONdition <SearchName>,<RepeatedStart>
SEARch:TRIGger:I2C:RCONdition? <SearchName>
Enables the search for a start condition without previous stop condition.
Protocols