R&S RTO6 - Page 1694

Remote control commands
R&S
®
RTO6
1694User Manual 1801.6687.02 ─ 05
Parameters:
<RepeatedStart> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:STCNdition <SearchName>,<Stop>
SEARch:TRIGger:I2C:STCNdition? <SearchName>
Enables the search for the start of the message.
Parameters:
<Stop> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:NACKnowledge <SearchName>,<NoAcknowledge>
SEARch:TRIGger:I2C:NACKnowledge? <SearchName>
Searches for missing address acknowledge bits.
Parameters:
<NoAcknowledge> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:SADDress <SearchName>,<Address>
SEARch:TRIGger:I2C:SADDress?
<SearchName>
Enables the search for one specific address condition or for a combination of address
conditions.
To define the address condition, use the following commands:
●
SEARch:TRIGger:I2C:ACONdition on page 1695
●
SEARch:TRIGger:I2C:ADDRess on page 1696
●
SEARch:TRIGger:I2C:ADDTo on page 1696
●
SEARch:TRIGger:I2C:AMODe on page 1696
●
SEARch:TRIGger:I2C:ACCess on page 1697
Parameters:
<Address> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols