Protocol analysis
R&S
®
RTO6
860User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:USBThree:IOPerator on page
2212
SEARch:
TRIGger:USBThree:FRAMe<m>:FLD<n>:IOPerator on page 2212
SEARch:TRIGger:USBThree:IMIN on page 2213
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:IMIN on page 2213
SEARch:TRIGger:USBThree:IMAX on page 2213
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:IMAX on page 2213
13.21.5.2 USB 3.1 search results
To get search results, "Enable" the search in the "Control" section of the "Search
Setup" dialog. You can minimize, shift or close the search dialog to better see the
"Search Results" table.
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:USBThree:FCOunt? on page 2215
●
SEARch:RESult:USBThree:FRAMe<m>:TYPE? on page 2214
●
SEARch:RESult:USBThree:FRAMe<m>:INFO? on page 2214
●
SEARch:RESult:USBThree:FRAMe<m>:STATe? on page 2215
●
SEARch:RESult:USBThree:FRAMe<m>:STARt? on page 2215
●
SEARch:RESult:USBThree:FRAMe<m>:STOP? on page 2216
●
SEARch:RESult:USBThree:FRAMe<m>:FLD<n>:TYPE? on page 2216
●
SEARch:RESult:USBThree:FRAMe<m>:FLD<n>:STATus? on page 2216
●
SEARch:RESult:USBThree:FRAMe<m>:FLD<n>:STARt? on page 2217
●
SEARch:RESult:USBThree:FRAMe<m>:FLD<n>:STOP? on page 2217
●
SEARch:RESult:USBThree:FRAMe<m>:FLD<n>:VAL? on page 2218
●
SEARch:RESult:USBThree:FRAMe<m>:FLD<n>:FVAL? on page 2218
13.21.5.3 Searching USB 3.1 data
Prerequisite: A serial bus is configured for the USB 3.1 signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1. Press the [Bus] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
USB 3.1 (option R&S R
T
O6-K570)
To Next Page
Loading...
