Remote control commands
R&S
®
RTO6
2443User Manual 1801.6687.02 ─ 05
24.19 Waveform generator (option R&S RTO6-B6)
24.19.1
Waveform generator setup
24.19.1.1 General
WGENerator<m>:ACOPy..............................................................................................2443
WGENerator<m>[:ENABle]........................................................................................... 2443
WGENerator<m>:SOURce............................................................................................2443
WGENerator<m>:PRESet.............................................................................................2443
WGENerator<m>:ACOPy
Copies all settings from Gen1/Gen2 and applies them to Gen2/Gen1.
Suffix:
<m>
.
1..2
Usage: Event
WGENerator<m>[:ENABle] <State>
Enables the waveform generator and outputs the waveform.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
WGENerator<m>:SOURce <OperationMode>
Sets the operation mode for the the waveform generator.
Suffix:
<m>
.
1..2
Parameters:
<OperationMode>
FUNCgen | MODulation | SWEep | ARBGenerator
*RST: FUNCgen
WGENerator<m>:PRESet
Sets the parameters of the waveform generator to their default values.
Suffix:
<m>
.
1..2
Waveform generator (option R&S RT
O6-B6)
To Next Page
Loading...
