Remote control commands
R&S
®
RTO6
2515User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..2
Parameters:
<ReverseLockPll> ON | OFF
*RST: ON
Usage: Asynchronous command
CDR:SOFTware<m>:SAMTime <UntIntvlOffs>
Sets a sampling time for the clock signal, an of
fset for the clock edge in relation to the
bit start. The clock edge sets the beginning of the unit interval. The sampling time is a
number between 0 and 1. Value 0 sets the clock edge to the beginning of the bit
period; value 0.5 sets the clock edge to the middle of the bit period.
Suffix:
<m>
.
1..2
Parameters:
<UntIntvlOffs> Range: 0 to 1
Increment: 0.01
*RST: 0.5
Default unit: UI
Usage: Asynchronous command
24.22.4 Clock data recovery (hardware-based, option R&S RTO6-K13)
CDR:HARDware:
SOURce............................................................................................ 2515
CDR:HARDware:SERStandard..................................................................................... 2516
CDR:HARDware:BREStimate........................................................................................2516
CDR:HARDware:BITRate............................................................................................. 2516
CDR:HARDware:ESLope..............................................................................................2516
CDR:HARDware:PLL:ORDer........................................................................................ 2516
CDR:HARDware:PLL:BWIDth....................................................................................... 2517
CDR:HARDware:PLL:RELBwidth...................................................................................2517
CDR:HARDware:PLL:DAMPing.....................................................................................2517
CDR:HARDware:SAMTime........................................................................................... 2517
TRIGger<m>:LEVel<n>[:VALue].................................................................................... 2518
CDR:HARDware:SOURce <AnalogSource>
Selects the channel signal that is used for clock recovery.
Parameters:
<AnalogSource> C1 | C2 | C3 | C4
*RST: C1
Usage: Asynchronous command
Jitter analysis and clock data recovery
To Next Page
Loading...
