Protocol analysis
R&S
®
RTO6
933User Manual 1801.6687.02 ─ 05
Disparity error
Searches for disparity errors.
Remote command:
SEARch:
TRIGger:EBTB:
DISParityerr on page 2341
Glitching error
Searches for glitching errors.
Remote command:
SEARch:TRIGger:EBTB:GLITcherror on page 2342
Unknown symbol error
Searches for a symbol that is not defined by the the 8b/10b.
Remote command:
SEARch:TRIGger:EBTB:UNK on page 2344
8b Pattern
Sets the 8-bit pattern to be searched for, if "Type" > "8-bit".
Remote command:
SEARch:TRIGger:EBTB:EBPA on page 2342
10b Pattern
Sets the 10-bit pattern to be searched for, if "Type" > "10-bit".
Remote command:
SEARch:TRIGger:EBTB:TBPA on page 2344
Expression
Defines the expression to be searched for, if "Type" > "Expression".
Remote command:
SEARch:TRIGger:EBTB:SYME on page 2343
13.25.5.2 8b/10b search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote Commands:
●
SEARch:RESult:EBTB:SCOunt? on page 2345
●
SEARch:RESult:EBTB:SYMBol<m>:DATA? on page 2345
●
SEARch:RESult:EBTB:SYMBol<m>:STARt? on page 2345
●
SEARch:RESult:EBTB:SYMBol<m>:STATus? on page 2345
8b/10b (option R&S R
T
O6-K590)
To Next Page
Loading...
