R&S RTO6 - 24.12.2 Results

Remote control commands
R&S
®
RTO6
1485User Manual 1801.6687.02 ─ 05
Parameters:
<State> ON | OFF
Enables or disables the measurement.
Parameters for setting and query:
<MeasType> See MEASurement<m>:MAIN
on page 1483.
Usage: Asynchronous command
MEASurement<m>:AON
Enables all additional measurements in all categories of the indicated measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Usage: Event
Asynchronous command
MEASurement<m>:AOFF
Disables all additional measurements in all categories of the indicated measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Usage: Event
Asynchronous command
24.12.2 Results
MEASurement<m>:ARES?........................................................................................... 1486
MEASurement<m>:ARNames
.......................................................................................1486
MEASurement<m>:RESult[:ACTual]?.............................................................................1487
MEASurement<m>:RESult:AVG?.................................................................................. 1487
MEASurement<m>:RESult:EVTCount?.......................................................................... 1487
MEASurement<m>:RESult:NPEak?...............................................................................1487
MEASurement<m>:RESult:PPEak?............................................................................... 1487
MEASurement<m>:RESult:RELiability?..........................................................................1487
MEASurement<m>:RESult:RMS?..................................................................................1487
MEASurement<m>:RESult:WFMCount?.........................................................................1487
MEASurement<m>:RESult:STDDev?.............................................................................1487
MEASurement<m>:RESult:STARt?................................................................................1489
MEASurement<m>:RESult:STOP?................................................................................ 1489
MEASurement<m>:RESult:COUNt?...............................................................................1489
Automatic measurements