Remote control commands
R&S
®
RTO6
1484User Manual 1801.6687.02 ─ 05
Eye diagram measurements
ERPercent | ERDB | EHEight | EWIDth | ET
OP | EBASe | QF
AC-
tor | RMSNoise | SNRatio | DCDistortion | ERTime | EFTime |
EBRate | EAMPlitude | PPJitter | STDJitter | RMSJitter
See Chapter 24.12.5, "Eye diagram measurements",
on page 1508
*RST value for eye/jitter measurements: ERPercent.
Spectrum measurements
CPOWer | OBWidth | SBWidth | THD | THDPCT | THDA | THDU
| THDR | PLISt | HAR | THDF | SPAR
See Chapter 24.12.6, "Spectrum", on page 1511.
*RST value for spectrum measurements: CPOWer.
Histogram measurements
WCOunt | WSAMples | HSAMples | HPEak | PEAK | UPEak-
value | LPEakvalue | HMAXimum | HMINimum | MEDian | MAX-
Min | HMEan | HSTDdev | M1STddev | M2STddev | M3STddev |
MKPositive | MKNegative
See Chapter 24.12.8.2, "Histogram measurement",
on page 1527.
*RST value for histogram measurements: WCOunt.
Protocol measurements
NONE | AUDio | F2F | F2A | FLDValue | GAP | MBITrate | SBI-
Trate | BIDLe | FCNT | FEC | FER | CFER
Requires option R&S RTO6-K500
See Chapter 24.12.11, "Protocol", on page 1539
Optical measurements
OAP | OMA
See Chapter 24.12.7, "Optical measurements", on page 1518.
Example: See "Simple frequency and amplitude measurement"
on page
1262.
See
"Creating and reading histograms" on page 1263
Usage: Asynchronous command
MEASurement<m>:ADDitional <MeasType>, <State>
MEASurement<m>:
ADDitional? <MeasType>
Adds additional measurements to the indicated measurement group. Only one mea-
surement can be enabled or disabled per command. The query returns the state of the
specified measurement.
Note that each measurement group must contain measurements from the same cate-
gory. For example, if the main measurement of measurement group 1 is amplitude,
then you cannot enable an eye width measurement in the same measurement group.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Automatic measurements
To Next Page
Loading...
