Acquisition and waveform setup
R&S
®
RTO6
172User Manual 1801.6687.02 ─ 05
5.7.1 R&S RT
-ZVC overview
5.7.1.1
Setup
Access: [App Cockpit]> "Analysis" > "Multi-channel probe" > "Setup" tab
Make sure that the tab of the correct probe is selected on the left side.
State
Enables the corresponding channel of the probe. The number of available channels
depend on the characteristics of your multi-channel power probe.
Remote command:
ZVC:Z<m>:V<n>[:STATe] on page 1375
ZVC:Z<m>:I<n>[:STATe] on page 1372
Scale
Defines the vertical scale for the channel in Volts per division. Increasing the scale
compresses the display of the signal. Within a given operation range, modifying the
scale is equivalent to scaling a display range.
For the voltmeter channels, the Scale, the Offset and the "Position" specify the operat-
ing range of the voltmeter.
Remote command:
ZVC:Z<m>:V<n>:SCALe on page 1374
ZVC:Z<m>:I<n>:SCALe on page 1370
R&S RT-ZVC probe
To Next Page
Loading...
