R&S RTO6 - 24.14 Mask testing; 24.14.1 Mask test definition

Remote control commands
R&S
®
RTO6
1582User Manual 1801.6687.02 ─ 05
24.14 Mask testing
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order
,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
T
o prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 24.3, "Programming examples", on page 1259
● Mask test definition............................................................................................. 1582
● Mask definition: user mask..................................................................................1586
● Mask definition: waveform mask.........................................................................1592
● Event actions.......................................................................................................1594
● Results................................................................................................................ 1597
● Eye mask testing.................................................................................................1599
24.14.1 Mask test definition
MTESt:ADD.................................................................................................................1582
MTESt:REMove...........................................................................................................1583
MTESt[:STATe]............................................................................................................ 1583
MTESt:SHOW............................................................................................................. 1583
MTESt:RST.................................................................................................................1583
MTESt:SOURce...........................................................................................................1584
MTESt:CONDition........................................................................................................1584
MTESt:TOLerance....................................................................................................... 1584
MTESt:CTYPe.............................................................................................................1585
MTESt:FILE:NAME...................................................................................................... 1585
MTESt:FILE:SAVE....................................................................................................... 1586
MTESt:FILE:OPEN.......................................................................................................1586
MTESt:FILE:DELete.....................................................................................................1586
MTESt:ADD <MaskTestName>
Creates a new mask test definition with the specified name.
Setting parameters:
<MaskTestName> String with the name of the mask test
Example: See Chapter 24.3.3.1, "Creating a user mask", on page
1265
Usage: Setting only
Asynchronous command
Mask testing