R&S RTO6 - 24.17.6.4 Track and trend

Remote control commands
R&S
®
RTO6
1750User Manual 1801.6687.02 ─ 05
<n> *
Selects the frame.
<o> 1..8
Selects the TDM channel.
Return values:
<Value> To set the value format, use FORMat:BPATtern
on page 1294.
The stated values for range, increment and reset are decimal
values.
Range: 0 to 4294967295
Increment: 1
*RST: 0
Usage: Query only
24.17.6.4 Track and trend
BUS<m>:I2S:TRACk:LEFT
........................................................................................... 1750
BUS<m>:I2S:TRACk:RIGHt.......................................................................................... 1750
BUS<m>:I2S:TRACk:TD1Ch.........................................................................................1750
BUS<m>:I2S:TRACk:TD2Ch.........................................................................................1750
BUS<m>:I2S:TRACk:TD3Ch.........................................................................................1750
BUS<m>:I2S:TRACk:TD4Ch.........................................................................................1750
BUS<m>:I2S:TRACk:TD5Ch.........................................................................................1751
BUS<m>:I2S:TRACk:TD6Ch.........................................................................................1751
BUS<m>:I2S:TRACk:TD7Ch.........................................................................................1751
BUS<m>:I2S:TRACk:TD8Ch.........................................................................................1751
MEASurement<m>:TRACk[:STATe]............................................................................... 1751
MEASurement<m>:TRACk:DATA:HEADer?....................................................................1751
MEASurement<m>:TRACk:DATA:STYPe?..................................................................... 1751
MEASurement<m>:TRACk:DATA[:VALues]?...................................................................1752
BUS<m>:I2S:TRACk:LEFT <Left>
BUS<m>:I2S:TRACk:RIGHt <Right>
Enables or disables the track of the indicated channel. The commands are relevant for
I²S standard, left-justified and right-justified audio data formats.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Left>, <Right> ON | OFF
*RST: OFF
BUS<m>:I2S:TRACk:TD1Ch <TDMCh1>
BUS<m>:I2S:TRACk:TD2Ch <TDMCh2>
BUS<m>:I2S:TRACk:TD3Ch <TDMCh3>
BUS<m>:I2S:TRACk:TD4Ch <TDMCh4>
Protocols