Compliance tests
R&S
®
RTO6
1216User Manual 1801.6687.02 ─ 05
21 Compliance tests
Thanks to the high measurement accuracy of the R&S RTO6, the oscilloscope can be
used for reliable compliance testing on the physical layer of high-speed bus interfaces.
For fast and easy compliance testing, you need the free-of-charge R&S ScopeSuite.
The software guides you step-by-step through the test sequences, configures the oscil-
loscope, automatically performs measurements and compiles the results in a measure-
ment report. Detailed, image-based instructions make it easy to connect the oscillo-
scope and the probes to the test fixture set and the device under test.
The R&S ScopeSuite can be installed on a test computer or directly on the R&S RTO6.
If the R&S ScopeSuite is installed on the oscilloscope, you can start it directly in the
firmware menu.
For best operation results, we recommend that the installed firmware versions of the
R&S ScopeSuite and the oscilloscope are the same.
Access: [App Cockpit] > "Compliance" tab
21.1 USB compliance test
The R&S RT
O6-K21 option enables the automatic testing of USB 2.0 compliance
(high-speed) as well as USB 1.1 (full-speed) and USB 1.0 (low-speed).
USB compliance test
To Next Page
Loading...
