R&S RTO6 - 13.10.6.2 SENT search results

Protocol analysis
R&S
®
RTO6
665User Manual 1801.6687.02 ─ 05
– "Pulse Period Error"
Searches for pulse period errors in a transmission sequence.
–
"Irregular Frame Length Error"
Searches for irregular frame length errors in a transmission sequence if pause
pulse mode is set to constant frame length..
●
Serial message error
–
"Form Error"
Searches for format errors in serial messages.
●
"CRC Error"
Searches for errors in the complete data transmission.
Remote command:
SEARch:TRIGger:SENT:PULSeerror on page 1923
SEARch:TRIGger:SENT:PPERioderror on page 1923
SEARch:TRIGger:SENT:FORMerror on page 1923
SEARch:TRIGger:SENT:CRCerror on page 1924
SEARch:TRIGger:SENT:IRFLength on page 1923
13.10.6.2 SENT search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:SENT:FCOunt? on page 1925
●
SEARch:RESult:SENT:FRAMe<m>:STATus? on page 1928
●
SEARch:RESult:SENT:FRAMe<m>:STARt? on page 1928
●
SEARch:RESult:SENT:FRAMe<m>:STOP? on page 1928
●
SEARch:RESult:SENT:FRAMe<m>:DATA? on page 1925
●
SEARch:RESult:SENT:FRAMe<m>:CSValue? on page 1925
●
SEARch:RESult:SENT:FRAMe<m>:IDTYpe? on page 1925
●
SEARch:RESult:SENT:FRAMe<m>:IDValue? on page 1926
●
SEARch:RESult:SENT:FRAMe<m>:NIBBle<n>:STATe? on page 1926
●
SEARch:RESult:SENT:FRAMe<m>:NIBBle<n>:VALue? on page 1926
●
SEARch:RESult:SENT:FRAMe<m>:PAPTicks? on page 1927
●
SEARch:RESult:SENT:FRAMe<m>:SCOM? on page 1927
●
SEARch:RESult:SENT:FRAMe<m>:SDATa? on page 1927
●
SEARch:RESult:SENT:FRAMe<m>:SYMBol? on page 1928
●
SEARch:RESult:SENT:FRAMe<m>:SYNCduration? on page 1929
SENT (option R&S R
T
O6-K520)