Protocol analysis
R&S
®
RTO6
545User Manual 1801.6687.02 ─ 05
BUS<m>:I2S:TRACk:TD2Ch on page
1750
BUS<m>:
I2S:TRACk:TD3Ch on page 1750
BUS<m>:I2S:TRACk:TD4Ch on page 1750
BUS<m>:I2S:TRACk:TD5Ch on page 1751
BUS<m>:I2S:TRACk:TD6Ch on page 1751
BUS<m>:I2S:TRACk:TD7Ch on page 1751
BUS<m>:I2S:TRACk:TD8Ch on page 1751
13.5.5.2 Track enabling in measurement setup
As the track is based on measurement, it can be set up in the "Result Analysis" tab of
the "Measurement" dialog box. Alternatively, you can enable the track in the protocol
display settings, see Chapter 13.5.5.1, "Track settings in protocol setup", on page 544.
To set the vertical scale of the track waveform, use analysis scale settings, see "Analy-
sis scale" on page 361.
Enable (Track)
Enables the track of measurement results over time and displays the track waveform. It
is the graphical interpretation of all measurement values of a single acquisition.
The track is available for most amplitude/time measurements (except for High, Low,
Amplitude, Max, Min, Peak to peak, Mean, RMS, S-dev, Pos. and Neg. overshoot, and
Area), and for jitter measurements.
Enabling the track enables also the Continuous auto scale and Measure all events in
each acquisition.
Before you can enable the track, activate the appropriate measurement.
Remote command:
MEASurement<m>:TRACk[:STATe] on page 1545
13.5.6 Trend
The trend is a special long-term measurement that shows the evolution of measure-
ment values in a running continuous acquisitions. For audio signals, each decoded
channel value is a measurement result that creates a point on the trend curve. You can
configure the number of points that builds the complete trend curve.
13.5.6.1
Displaying and configuring the trend
If an audio bus is configured, you can set up the trend measurement for audio chan-
nels. The following procedure describes the complete trend setup using the "Setup"
dialog.
1. Select "Setup".
2. Select the "Category" = "Protocol".
Audio signals (option R&S R
TO6-K510)
To Next Page
Loading...
