Remote control commands
R&S
®
RTO6
1747User Manual 1801.6687.02 ─ 05
Parameters:
<SequenceOfWords> Range: 1 to 1000000
Increment: 1
*RST: 1
Default unit: word
Usage: Asynchronous command
TRIGger<m>:I2S:WSSLope <WSSlope>
Sets the edge of the WS or FSYNC signal as trigger condition. The instrument triggers
on the first clock edge after the specified edge.
Parameters:
<WSSlope> POSitive | NEGative
*RST: POSitive
Usage: Asynchronous command
24.17.6.3 Decode results
BUS<m>:I2S:FCOunt?................................................................................................. 1747
BUS<m>:I2S:FRAMe<n>:ST
ATe?..................................................................................1747
BUS<m>:I2S:FRAMe<n>:STARt?..................................................................................1748
BUS<m>:I2S:FRAMe<n>:STOP?.................................................................................. 1748
BUS<m>:I2S:FRAMe<n>:LEFT:VALue?......................................................................... 1748
BUS<m>:I2S:FRAMe<n>:RIGHt:VALue?........................................................................1748
BUS<m>:I2S:FRAMe<n>:LEFT:STATe?......................................................................... 1749
BUS<m>:I2S:FRAMe<n>:RIGHt:STATe?........................................................................1749
BUS<m>:I2S:FRAMe<n>:TDM<o>:STATe?.................................................................... 1749
BUS<m>:I2S:FRAMe<n>:TDM<o>:VALue?.................................................................... 1749
BUS<m>:I2S:FCOunt?
Returns the number of decoded frames.
Suffix:
<m>
.
1..4
Selects the serial bus.
Return values:
<Count> Number of decoded audio frames
Usage: Query only
BUS<m>:I2S:FRAMe<n>:STATe?
Returns the overall state of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
Protocols
To Next Page
Loading...
