Remote control commands
R&S
®
RTO6
1552User Manual 1801.6687.02 ─ 05
●
EXECutable:PARameter
on page 1669
●
EXECutable:WDIRectory on page 1669
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<RunExecutable>
NOACtion | SUCCess | VIOLation
See Chapter 24.4.5, "Event parameter", on page 1286
*RST: NOACtion
Usage: Asynchronous command
24.12.15 Reference levels
● General reference level settings.........................................................................
1552
● Automatic configuration.......................................................................................
1554
● Manual configuration...........................................................................................1556
● Hysteresis........................................................................................................... 1561
● Tube....................................................................................................................1561
● Results................................................................................................................ 1563
24.12.15.1 General reference level settings
REFLevel<m>:LDETection............................................................................................1552
REFLevel<m>:LMODe................................................................................................. 1553
REFLevel<m>:RELative:MODE.....................................................................................1553
REFLevel<m>:USRLevel.............................................................................................. 1554
REFLevel<m>:LDETection <Mode>
Defines whether the reference level is configured manually or automatically.
For automatic configuration, select the signal level to be used (see REFLevel<m>:
AUTO:MODE on page 1554).
Suffix:
<m>
.
V
alid suf
fix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Mode> AUTO | MANual
Example:
REFLevel2:LDETection MANual
Sets manual level configuration for C1W1. C1W1 corresponds to
suf
fix number 2.
Automatic measurements
To Next Page
Loading...
