R&S RTO6 - Page 1551

Remote control commands
R&S
®
RTO6
1551User Manual 1801.6687.02 ─ 05
MEASurement<m>:ONViolation:WFMSave <SaveWfm>
Saves the waveform data.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<SaveWfm>
NOACtion | SUCCess | VIOLation
See Chapter 24.4.5, "Event parameter", on page 1286
*RST: NOACtion
Usage: Asynchronous command
MEASurement<m>:ONViolation:REPort <Report>
Creates and saves a report of the current settings and results.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<Report> NOACtion | SUCCess | VIOLation
See
Chapter 24.4.5, "Event parameter", on page 1286
*RST: NOACtion
Usage: Asynchronous command
MEASurement<m>:ONViolation:TRIGgerout <TriggerOutPulse>
Creates a trigger out pulse on limit or margin violation or on successful completion of
the measurement.
Suffix:
<m>
.
1..10
Parameters:
<T
riggerOutPulse> NOACtion | SUCCess | VIOLation
*RST: NOACtion
Usage: Asynchronous command
MEASurement<m>:ONViolation:RUNexec <RunExecutable>
Starts an external application if the command is set to VIOLation or SUCCess.
Use the following commands to set up the application:
●
EXECutable:NAME
on page 1668
Automatic measurements