Remote control commands
R&S
®
RTO6
2162User Manual 1801.6687.02 ─ 05
TRIGger<m>:USB:WPID <WithPIDCheck>
Defines, whether the packet ID error check shall be activated or not.
Parameters:
<WithPIDCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WPOR <WithPortCheck>
Defines, whether the port check shall be activated or not.
Parameters:
<WithPortCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WSEU <WithSEUCheck>
Defines, whether the SEU check shall be activated or not.
For SEU, see "SEU" on page 831.
Parameters:
<WithSEUCheck>
ON | OFF
*RST: OFF
TRIGger<m>:USB:WSTC <WithSCCheck>
Defines, whether the Start / Complete (SC) check shall be activated or not.
Parameters:
<WithSCCheck> ON | OFF
*RST: OFF
24.17.21.3 Decode results
In all BUS<m>:USB:PACKet<n> commands, the suf
fix <m> selects the serial bus and
the suffix <n> selects the packet number in the decode table.
► Query the status of packet #19: BUS:USB:PACKet19:STAT?
The result of this remote command query should be "OK".
BUS<m>:USB:PACKet<n>:PID?....................................................................................2163
BUS<m>:USB:PACKet<n>:ADDRess?...........................................................................2164
BUS<m>:USB:PACKet<n>:CRC?.................................................................................. 2164
BUS<m>:USB:PACKet<n>:DATA?.................................................................................2165
BUS<m>:USB:PACKet<n>:ENDPoint?...........................................................................2165
BUS<m>:USB:PACKet<n>:ET?.....................................................................................2165
BUS<m>:USB:PACKet<n>:FRAMe?.............................................................................. 2165
Protocols
To Next Page
Loading...
