Remote control commands
R&S
®
RTO6
2060User Manual 1801.6687.02 ─ 05
BUS<m>:RFFE:VERSion <V
ersion>
Selects the RFFE version.
Suffix:
<m>
.
1..4
Parameters:
<V
ersion> V1DX | V2D0 | V2D1 | V3D0
V1DX: 1.x
V2D0: 2.0
V2D1: 2.1
*RST: V1DX
24.17.18.2 Trigger
The trigger suf
fix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
For programming examples, see "Triggering on RFFE bus" on page 1274.
TRIGger<m>:RFFE:TYPE.............................................................................................2061
TRIGger<m>:RFFE:ADDRess:CONDition...................................................................... 2063
TRIGger<m>:RFFE:ADDRess:MIN................................................................................2063
TRIGger<m>:RFFE:ADDRess:MAX...............................................................................2064
TRIGger<m>:RFFE:BCOunt:CONDition......................................................................... 2064
TRIGger<m>:RFFE:BCOunt:MIN...................................................................................2064
TRIGger<m>:RFFE:BCOunt:MAX..................................................................................2064
TRIGger<m>:RFFE:DATA:DCON.................................................................................. 2065
TRIGger<m>:RFFE:DATA:DMIN....................................................................................2065
TRIGger<m>:RFFE:DATA:DMAX...................................................................................2065
TRIGger<m>:RFFE:DATA:ICONdition............................................................................ 2065
TRIGger<m>:RFFE:DATA:IMIN..................................................................................... 2066
TRIGger<m>:RFFE:DATA:IMAX.................................................................................... 2066
TRIGger<m>:RFFE:SADD:CONDition............................................................................2066
TRIGger<m>:RFFE:SADD:MIN..................................................................................... 2067
TRIGger<m>:RFFE:SADD:MAX.................................................................................... 2067
TRIGger<m>:RFFE:MASK:CONDition............................................................................2067
TRIGger<m>:RFFE:MASK:MAX....................................................................................2067
TRIGger<m>:RFFE:MASK:MIN..................................................................................... 2067
TRIGger<m>:RFFE:INTerrupt........................................................................................2068
TRIGger<m>:RFFE:ERRor:BP...................................................................................... 2068
TRIGger<m>:RFFE:ERRor:LENGth...............................................................................2068
TRIGger<m>:RFFE:ERRor:NOResponse.......................................................................2068
Protocols
To Next Page
Loading...
